Rexco MS150-11 (11KW,15HP)
26 พฤศจิกายน 2563
ผู้ชม 834 ผู้ชม
MS series of water cooling submersible motor is a new product made by our company.It has the advantages of high efficiency,energy saving and environment friendly.
CHARECTERS
Meet the requirements of Standard IEC34-1 with sealed water cooling lubricated design,non-polluction.
The dimension of flange and spline meet the requirements of NEMA Standard (USA National Electrical Manufacturing Association).
The outer shells of motor and the shafts are made of stainless steel as well as the fixings.Other parts are rust-proof. The main bearing that the thrust bearing have the claracter of anti wearing and undertake higher thrust load.
With anti-sand installation and reformed butyl-rubber pressure equilibrium membrane.
PROPERTIES
Power:Three-phase,5.5kw-37kw
Voltage and frequency:Three-phase,380V/460V,50/60Hz.
Protection device class:IP68.
Maximum starts per hour:30 times
Surrounding water temperature should not be higher than 30℃
The content of solid should not be higher than 0.01%.
pH value of water:6.5-8.0
Thrust load:15,500N for at or under 15kw; 30000N for 18.5kw to 37kw.
Flat cable with individual ground wire:3x6.0mm2 or 3x10.0mm2 waterproof connect cable length:1.5-4m
MATERIAL
Stainless steel 304 or cast iron flange upper bracket
Cooper or cast aluminium bar rotor
304 SS outer shell,cold rolled silicon stator and rotor
Thrust bearing made of special material
Cast iron or stainless steel 304 upper bracket and low support